When i boot the routers, no probs. When i change the ip adress(of the ethernet interface) and put in some static ip routes and then 'reload', it simply forgets the ip adress and i have to start all over again.
I tried the 'write memory' command and 'save startup-config running config'. What could be the problem?
Well, i tried to put it to 0x2102, i thought this was the solution but it isnt. I set it, then reloaded. I putted in a ip adress and host name. Then a copy run AND copy start, also a write mem command, then it reloaded and it lost the memory, bye ip adress, bye host name.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.