04-28-2003 03:27 AM - edited 03-02-2019 06:57 AM
Hello
We have Catalysts 6500 with the WS-X6K-SUP1A-2GE supervisor, and with the WS-F6K-MSFC on them.
The paper on http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_14357.htm says:
"
the Supervisor Engine 1A with an MSFC (WS-X6K-SUP1A-MSFC) is not field upgradable. Removing and re-installing the MSFC could damage your supervisor engine. "
Can we or can we not upgrade memory on this Supervisor?
Thanks in advance
//Robert Frånberg
04-28-2003 05:07 AM
Hello
I have found this url too http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/6000hw/mod_inst/04upgrd.htm#1032161
wich don't speak about your field notice.
Anyway, we have upgrade the memory on WS-X6K-SUP1A-2GE with WS-F6K-MSFC2 and we haven't met problem.
I think that the message means that you don't have do remove the msfc card.
Regards.
04-28-2003 10:43 PM
I think that the original question is about a supervisor mem upgrade not an MSFC upgrade.
Check out the supervisor 128 MB mem upgrade doc:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_14357.htm
You can find the link from any release notes for CatOS version 7.5(1) and up. 128 Mem may be needed to run CatOS 7.5(1) and up.
Cheers
04-28-2003 11:22 PM
It is correct that the question is about upgrade of the memory on the Supervisor from 64->128Mb. This is due to CatOS 7.6(1) requires 128Mb, as specified in the same URL stated in my question.
It is the term "is not field upgradable" i wounder about. Can it be upgraded by a authorized Cisco personel or can i send it to Cisco and have them upgrade the Supervisor.
04-29-2003 04:06 AM
The above document is for
WS-X6K-S1A-MSFC2
WS-X6K-SUP1A-PFC
WS-X6K-SUP1A-2GE
If you have an MSFC, we normally do not recommend field upgrade. I suggest that you open a TAC case and have a Supervisor RMAed which already has 128MB DRAM
02-09-2004 07:45 AM
Hi Roobert,
We are facing same problem. Can please let me know what you did to resolve this issue
Regards,
VIjay Tandon
02-10-2004 06:33 PM
To upgrade to 128-MB DRAM on the WS-X6K-SUP1A-MSFC, use the MEM-S1-128MB-UPG= upgrade kit which also includes an MSFC2 upgrade.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_1982.htm#20785
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: