Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

message on Cat6500

Hi,

when I insert a GBIC in a 16-port Gigabit module I get the following messages:2003 Nov 15 05:55:50 PST -08:00 %SYS-3-PORT_GBICNOTSUPP:Port 2/11 gbic not supported

2003 Nov 15 05:55:50 PST -08:00 %SYS-3-PORT_GBICBADEEPROM:Port 2/11 bad gbic eeprom checksum

2003 Nov 15 05:55:57 PST -08:00 %SYS-3-P2_ERROR: 1/Port 2/11 : Gbic's seeprom is bad, try reinserting

But the port is functioning correctly.

What shall I do? In a other switch the GBIC seems to be okay.

Regards

Peter

3 REPLIES
New Member

Re: message on Cat6500

What code are you running. Sounds like CSCds41239.

New Member

Re: message on Cat6500

At the moment there is 8.1.3 running.

New Member

Re: message on Cat6500

Then check the field notice below. Read Workaround/Solution carefully.

http://www.cisco.com/warp/public/770/fn16751.shtml

107
Views
0
Helpful
3
Replies
CreatePlease to create content