Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

metric weights of EIGRP

As recent working on Cisco 3640, when using eigrp, calculating patch cost, found that the metric weights are not default as k1=1 (bandwidth), k3=1 (delay).

Actually, k3=0 (delay) is zero by default. Any one has comments or update of these default weights? thanks!

3 REPLIES
Cisco Employee

Re: metric weights of EIGRP

The default values for K are:

K1 = 1

K2 = 0

K3 = 1

K4 = 0

K5 = 0

http://www.cisco.com/warp/public/103/eigrp1.html

HTH

R/Yusuf

New Member

Re: metric weights of EIGRP

thanks, you are right. but when setting metric weights 0 1 1 1 0 0 to enable load considering, the router could not exchange route information with other routers.

New Member

Re: metric weights of EIGRP

Hi.

The other routers have to have the same metric weights in order to be EIGRP neighbors with the router you are working on. If the K values don't match they won't be neighbors.

Hope this helps.

Regards,

NM

565
Views
0
Helpful
3
Replies
CreatePlease login to create content