Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MetroE Route Setup

I need some help. I need to configure 2 3560's to route to each other connected via a MetroE PtP setup with a dot1g tunnel. One side uses a firewall for its gateway, the other needs to use the route on the switch for its default gateway. I would like the IP for side A (with the firewall) to be 192.168.0.1 and side B to be 192.168.1.1. Any help would be great. If it would be easier to trunk, please let me know.

1 REPLY
Silver

Re: MetroE Route Setup

From Switch_A when you send dot1q tagged frames, they will be received by the dot1q-tunnel port on Switch_B. And the dot1q-tunnel port on Switch_B will be a part of a VLAN, let's say for example VLAN 100. All the dot1q-tagged frames coming from CatSwitch_A will be again (double) tagged with this VLAN 100. Better you implement the static routes .

124
Views
0
Helpful
1
Replies