Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%MGMT-4-OUTOFNVRAM:Out of NVRAM space, when new modules added

Hello,

I have added to new 48-port modules (WS-X6348-RJ-45) in slots 12 and 13 of a Catalyst 6513 running 7.3.(1).

When issuing configuration commands i get the following message:

2003 May 23 12:33:43 %MGMT-4-OUTOFNVRAM:Out of NVRAM space: (12,26640,524288,9268)

There are some articles at the Web explaining this error and the workaround that is to Move the ACL configuration to Flash memory, or clear the configuration for modules not in use.

According with this workaround i removed a QOS ACL previously defined so that no acl exists anymore in the configuration, but the error persist.

Does anyone know what else to do?.

Kind regards.

Albert.

1 REPLY
Cisco Employee

Re: %MGMT-4-OUTOFNVRAM:Out of NVRAM space, when new modules adde

Save the config to text (from binary) and point the config file to bootflash: or the flash card in slot0:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_2/cmd_ref/ses_sete.htm#31174

If you change the config mode, make sure you save the config each time you make a change with "write mem" command

137
Views
0
Helpful
1
Replies
CreatePlease login to create content