Hello all, I have two questions. The new 4506 SUP V engines don't have the good old SCO interface that I'm used to. So, since it's running an IOS now instead of the old CATos, I figured I'l create a new vlan and then make it the management IP address by using the 'MANAGEMENT' command (like in the old 2900's). Well, that didn't work either, so my question is...on what int. do I configure the mgnt. IP address?
Just think of Cat4506 with SupV like being a router: Any L3 interface can be used for mgmt. This can be either physical with "no switchport" configured and IP address assigned or logical e.g. interface vlan (and IP address assigned).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...