I am just wondering if someone has seen the following command on the Cisco MGX. I can't seem to find any information on google or cisco. This command doesn't look complete to me. But any ideas, if someone has seen the following command or if it's missing what's the COMPLETE one is.
End-to-End is an ATM OAM cell sent to the ATM interface of the far-side device...for instance:
MGX -- ATM-switch -- GSR
The end-to-end would be sending the OAM to the subinterface/VC on the ATM interface on the GSR. The segment loopback is VC-based verification between the MGX and the connected ATM-switch. Many applications connect the MGX directly into the router so the end-to-end and segment loopback may, in your case, be the same.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.