Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGX 8850

HI all,

Please i need to know, how to see the status of E3 line or port of MGX 8850 and how to test the port with loop test, which commands i can use.

Thanks & best Regards

4 REPLIES
Silver

Re: MGX 8850

Well the first thing you need to do is to go to the card in question by using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

Silver

Re: MGX 8850

Well the first thing you need to do is to go to the card in quest but using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

Silver

Re: MGX 8850

Well the first thing you need to do is to go to the card in question but using the command cc then after that you should be able to display the lines and the command for a loop is addlnloop

New Member

Re: MGX 8850

Hi,

In order to check the status of E3 line on MGX , u have to give the command " dspln -ds3 x.y " example dspln -ds3 1.1

and for the loop use command addlnloop.

Rgds,

Renu

108
Views
0
Helpful
4
Replies
CreatePlease login to create content