Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

mgx cell suppression

Hi,

Any idea if cell (idle) suppresion is supported

on MGX 8850 CESM T1/E1 and CESM T3/E3 cards when using unstructured data transport.

If yes how do i enable it

Thanks

Kostas

2 REPLIES

Re: mgx cell suppression

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: mgx cell suppression

Hi !!!

My name is Kevin

It looks like you cannot enable idle suppression on unstuctured lines. I tried setting this up in the lab. When you do a "cnfchan" to enable it, it comes back and says you cannot enable it on when the signaling is basic. The other problem is that you can't configure a port for unstructure in CAS mode.

Hope this helps. Do you have any VISM'S in your network. I am looking for AAL2 trunking configs.

Regards, Kevin

102
Views
0
Helpful
2
Replies