Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MGX FRSM Directional CIR

Is there a way to set 2 different values of BW on a FRSM port on a MGX 8850, so that the Egress value is less than the ingress value, i tried both cnfchanpool and xcnfchan with no luck as they alyways assume i'm oversubscribing the egress value not the ingress one.

Regards

2 REPLIES

Re: MGX FRSM Directional CIR

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: MGX FRSM Directional CIR

You should be able to set this using the xcnfchan command.

note the options below :

-ingut where ingut = 1-100

-egut where egut = 1-100

-egrat where egrat = 2400-2048000

The CIR would be your ingress and the -egrat would be your channel egress service rate..

Note the channel 16 config below :

-------------------------------------------------

ChanNum: 16

ChanRowStatus: Mod

ChanPortNum: 1

ChanDLCI: 100

EgressQSelect: 2

IngressQDepth: 65535

IngressQDEThresh: 32767

IngressQECNThresh: 6553

EgressQDepth: 65535

EgressQDEThresh: 32767

EgressQECNThresh: 6553

DETaggingEnable: Disabled

CIR: 1536000

Bc: 5100

Be: 5100

IBS: 100

ForeSightEnable: Disabled

QIR: 4000

MIR: 4000

PIR: 4000

ChanLocalRemoteLpbkState: Disabled

Type to continue, Q to stop:

ChanTestType: TestOff

ChanTestState: NotInProgress

ChanRTDresult: 65535 ms

ChanType: NIW

ChanFECNmap: setEFCIzero

ChanDEtoCLPmap: mapCLP

ChanCLPtoDEmap: mapDE

ChanFrConnType: PVC

ChanIngrPercentUtil: 100

ChanEgrPercentUtil: 100

ChanEgrSrvRate: 51200

ChanOvrSubOvrRide: Enabled

ChanLocalVpi: 0

ChanLocalVci: 100

ChanLocalNSAP: 6d6778383235302d000000000000000014000100

ChanRemoteVpi: 0

ChanRemoteVci: 0

ChanRemoteNSAP: NULL NSAP

ChanMastership: Slave

ChanVpcFlag: Vcc

ChanConnServiceType: ATFR

================================

Hope this helps.

Regards

Shajith

140
Views
0
Helpful
2
Replies