MGX8230 back - to -back

[6jgodinez]

Hi, Is there a way to connect two mgx 8230 back to back with the oc-3 pxm-1 port?

I'm trying to pass e1 traffic from one CESM E1 to other. This is the lab setup:

e1--cesm-mgx8230-pxm1 --- pxm1-mgx8230--cesm--e1

Thank you in advance.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.