I have a small network of 4 MGX8830/8850 (PXM1E). The atm0 addresses are all in a 220.127.116.11/24 subnet, but each has its lnPci0 address in a different 10.x.x.x/24 network. I have a CWM on the same 10.x.x.x subnet as one of the MGX8830s which is to monitor all the MGXs. This MGX8830 also has an RPM-PR.
Could somebody help point me in the right direction on how to set the management of these up, (i.e. arp server config on the RPM, whether I need to consider a different config approach), as I do not seem to be able to get any devices leant on the CWM, and I need to be able to telnet to each box from any location.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...