Here is the hardware limitation description to MHSRP. I don't believe that the 2600 is affected, but do a show int to check:
"Ethernet Several Ethernet (Lance and QUICC) controllers in low-end products can only have a single unicast MAC address in their address filter. On these platforms only a single HSRP group is permitted, and the interface address is changed to the HSRP virtual MAC address when the group becomes Active. If you're using HSRP on routers with multiple interfaces of this type, you should configure each interface with a different HSRP group number. "
The key here is the ethernet controller "Lance".
router#show interface ethernet 0
Ethernet0 is up, line protocol is up
Hardware is Lance, address is 0010.7b36.1be8 (bia 0010.7b36.1be8)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.