Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mib variable for 3640

i have a 3640 with primary isdn and mica modems providing 30 lines of dial in access for isdn / analogue users.

is there a mib variable i can use to send an snmp trap when a percentage of the lines - say 80% are in use.

any suggestions would be appreciated

regards

mark

1 REPLY
Blue

Re: mib variable for 3640

There are isdn traps which you can look in the IOS command ref. But for this, you need to setup an alarm/event to generate when say the line is 80% in use, provided that such mib object is available to use first.

90
Views
0
Helpful
1
Replies