Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Mica Modem and BRI interface!!!

Hi,

I'm trying to get a RAS connection to work using a remote PC and Modem to dial up via PPP into a 3640 BRI interface and have the Call terminate on the Mica Modem module. I'm getting the following error though;

00:10:05: %CSM-1-HWREV: The T1 or E1 network module is incompatible with the dig

ital modems: MODEM_REPORT

Can you help please?

regards

Paul

4 REPLIES
New Member

Re: Mica Modem and BRI interface!!!

It's not a WIC-1B-S/T module by any chance?

New Member

Re: Mica Modem and BRI interface!!!

Yes it is, just a standard BRI interface WIC. Will it not work so and if no why not?

Thanks

Paul

New Member

Re: Mica Modem and BRI interface!!!

WIC BRI do not support MICA modems..... the smallest card you can used are the NM-4B....

It's just the way cisco make them I guess... It's to do with the CSMs....check with the TAC.. I am sure they will tell you the same thing....

BR, Winnie

Bronze

Re: Mica Modem and BRI interface!!!

Paul,

WIC card's are do not have internal digital modem support. It needs to be a BRI network module to have this capability. In this doc if you go to features and look at the last point it specifically says that WIC's are not supported for MICA.

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_tech_note09186a008009454c.shtml#feat

Daniel

91
Views
0
Helpful
4
Replies
CreatePlease login to create content