We were recently aquired and will very soon need to migrate from EIGRP to OSPF. I have heard that you can run both (If configured properly), but as our infrastructure is relatively small, it makes more sense just to use OSPF alone. Are there any special considerations or potential problems that we should be aware of?
so long, you bring up all the networks of EIGRP get connected throu ospf ,i hope it wont be a problem.And as per your info, as your network is small you could do this.So goin for ospf alone cant be a problem
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...