Missing DHCP Option 43 (PXE) with ip helper-address
We used to boot out workstations with PXE boot but since we have implemented VLAN´s with ip helper adresses the workstations only get an IP but whrere not able to connect to the PXE Boot Server on Port 4011.
I have sniffed the communication an saw a difference in the DHCP packets. In the switched environment I can see a Option 43 with suboption 8, defining my PXE Server IP but with VLAN there is no PXE Boot Server Option.
We are using two Cat 4500 with VLAN and HSRP configured. The interface is in spanningtree portfast.
Re: Missing DHCP Option 43 (PXE) with ip helper-address
If you sniff the DHCP server on the remote network, does it send a DHCP response with option 43 ?
If the DHCP response from the remote DHCP server has option 43 set, but the DHCP response relayed to the PXE client from the cat4500 doesn't then I'd suggest you open a TAC case so that TAC can investigate the issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...