11-19-2001 09:26 AM - edited 03-01-2019 07:27 PM
I am attempting to configure my 1605R to utilize NTP for it's system/hardware time. I have never configured NTP on such a low-end device. I have always forced syncronization using "ntp update-calendar", but this appears to be missing. I have the following NTP commands available:
----------------------------
cisco1605R(config)#ntp ?
access-group Control NTP access
authenticate Authenticate time sources
authentication-key Authentication key for trusted time sources
broadcastdelay Estimated round-trip delay
clock-period Length of hardware clock tick
master Act as NTP master clock
max-associations Set maximum number of associations
peer Configure NTP peer
server Configure NTP server
source Configure interface for source address
trusted-key Key numbers for trusted time sources
----------------------------
I have established the following configuration:
#> ntp server 192.5.5.250 prefer (clock.isc.org - Palo Alto)
With the following snipping from my access control list:
#> permit udp any any eq ntp log
I cannot get my system clock to syncronize with the NTP server. The following is the result:
----------------------------
cisco1605R#show ntp status
Clock is unsynchronized, stratum 16, no reference clock
nominal freq is 252.0161 Hz, actual freq is 252.0161 Hz, precision is 2**7
reference time is 00000000.00000000 (18:00:00.000 cst Thu Dec 31 1899)
clock offset is 0.0000 msec, root delay is 0.00 msec
root dispersion is 0.00 msec, peer dispersion is 0.00 msec
----------------------------
----------------------------
cisco1605R#show ntp associations
address ref clock st when poll reach delay offset disp
~192.5.5.250 0.0.0.0 16 - 64 0 0.0 0.00 16000.
* master (synced), # master (unsynced), + selected, - candidate, ~ configured
----------------------------
What am I doing wrong?
11-27-2001 07:04 AM
Are you sure you can get to 192.5.5.250? Make sure your link is up and no firewall is blocking.
11-27-2001 03:29 PM
Not sure if this help but, here's my 1601R config lines (I have SNTP support, but not full NTP support):
clock timezone EST -5
clock summer-time EDT recurring last Sun Apr 2:00 last Sun Oct 2:00
sntp server 89.0.74.24
Here's a SH SNTP, and the IOS version I'm running is c1600-ny-mz.120-9.bin...
rtrdt-go#sh sntp
SNTP server Stratum Version Last Receive
89.0.74.24 3 1 00:00:09 Synced
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide