Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Missing serials on 2503 ?

I can't "see" serials intf on one 2503 I got over today. Just a brio and eth0. Are they defect or is there a prob with IOS/RAM/FLASH ?

sh ver:

IOS (tm) 3000 Software (IGS-G-L), Version 11.0(5), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1996 by cisco Systems, Inc.

Compiled Mon 05-Feb-96 23:39 by hochan

Image text-base: 0x0301C994, data-base: 0x00001000

ROM: System Bootstrap, Version 5.2(5), RELEASE SOFTWARE

ROM: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE (fc

1)

Router uptime is 17 minutes

System restarted by power-on

System image file is "flash:ii11050n.", booted via flash

cisco 2500 (68030) processor (revision D) with 1020K/1024K bytes of memory.

Processor board ID 01975602, with hardware revision 00000000

Bridging software.

Basic Rate ISDN software, Version 1.0.

1 Ethernet/IEEE 802.3 interface.

1 ISDN Basic Rate interface.

32K bytes of non-volatile configuration memory.

4096K bytes of processor board System flash (Read ONLY)

Configuration register is 0x2102

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Missing serials on 2503 ?

The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.

2 REPLIES
Silver

Re: Missing serials on 2503 ?

The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.

Community Member

Re: Missing serials on 2503 ?

Thank you very much for your input.

What is version I should use or what image I should use ? I have a lot of images but I am not shure which one is less "memory-hungry". Or should I go for IOS 12 to get WAN features?

Thank you again...

196
Views
0
Helpful
2
Replies
CreatePlease to create content