09-21-2005 08:52 PM - edited 03-03-2019 12:08 AM
Hello. When I telnet into my 3750, and then I ENABLE to get priviledge commands, I want to SET the SPANNING-TREE parameter.
I type SET ? and only get one option
MEMORY set memory paramters
When I type SHOW ?, I do see the parameter to show the SPANNING-TREE information.
Is there something else I need to enable?
Thanks, for your help...Jake
09-21-2005 09:44 PM
Ok, I've got some more information...
To set this parameter I can use the NO command such as
no spanning-tree bpduguard enable
but when I type ? two choices are given for the command NO. How do I use the second one?
When I type NO ?, I have the options of
Debug
IP
VTP
So any ideas?
thanks, Jake
09-22-2005 01:08 AM
ok, I figured out my problem...I feel like such a newb...
I had to get into the CONFIG mode then many more options were possible.
I figured out how to set the spanning-tree, then immediately got PORT-SECURITY errors about 1 every second. I didn't easily see how to disable that feature from Telnet, but was able to from the Cisco Network Assistant and/or the Java based web interface.
Once I turned off/disabled Port security for that port a SHOW RUNNING-CONFIG did not even display anything for that port. Guess that's to be expected, I would have preferred to see disabled, but finally, FINALLY, I can communicate with the network and internet.
All this just for testing purposes and a slow migration to the new switches.
Jake
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: