Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Missing SET parameters on 3750 switch via Telnet?

Hello. When I telnet into my 3750, and then I ENABLE to get priviledge commands, I want to SET the SPANNING-TREE parameter.

I type SET ? and only get one option

MEMORY set memory paramters

When I type SHOW ?, I do see the parameter to show the SPANNING-TREE information.

Is there something else I need to enable?

Thanks, for your help...Jake

2 REPLIES
New Member

Re: Missing SET parameters on 3750 switch via Telnet?

Ok, I've got some more information...

To set this parameter I can use the NO command such as

no spanning-tree bpduguard enable

but when I type ? two choices are given for the command NO. How do I use the second one?

When I type NO ?, I have the options of

Debug

IP

VTP

So any ideas?

thanks, Jake

New Member

Re: Missing SET parameters on 3750 switch via Telnet?

ok, I figured out my problem...I feel like such a newb...

I had to get into the CONFIG mode then many more options were possible.

I figured out how to set the spanning-tree, then immediately got PORT-SECURITY errors about 1 every second. I didn't easily see how to disable that feature from Telnet, but was able to from the Cisco Network Assistant and/or the Java based web interface.

Once I turned off/disabled Port security for that port a SHOW RUNNING-CONFIG did not even display anything for that port. Guess that's to be expected, I would have preferred to see disabled, but finally, FINALLY, I can communicate with the network and internet.

All this just for testing purposes and a slow migration to the new switches.

Jake

117
Views
0
Helpful
2
Replies