Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Mistake on setting interfaces default

This is the scenario: Router 2600

I have a serial port configured as follows:

interface Serial0

description Test 56 kbps Circuit #TEST-New

ip address 10.20.1.1 255.255.255.224

ip route-cache

ip mroute-cache

bandwidth 256

no shutdown

ipx network BBOQ1155

________________________________________

How do I wipe out all information on the serial interface and set the interface back to factory defaults (i.e. empty) with one command? I have a lot of routers that need to be reset and this would help a lot.

tia

regards,

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Mistake on setting interfaces default

from enabled mode type "setup" and this should trigger the setup wizard.

2 REPLIES
New Member

Re: Mistake on setting interfaces default

from enabled mode type "setup" and this should trigger the setup wizard.

New Member

Re: Mistake on setting interfaces default

depending on how new your ios is, you can also type in "default interface serial 0" from the config prompt

Rowan

92
Views
5
Helpful
2
Replies
CreatePlease to create content