Mixing DHCP and static addresses on same UBR72xx

[s-gosar]

We use DHCP to assign the dynamic IP to our client's devices. For the devices that do not support DHCP we are forced to handouve static IP address.

I am looking for a way to tie down this address to a MAC so that the allocated IP can not be hijacked by other users.

On the ethernet interfaces, I normally do this by adding a static ARP entry. How do I achive the same for the cable interface?

You can use my mail ID to send me your help. Thanks in advance.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.