Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MLPPP and ACL problem

I have a customer that has a 2621xm router, 12.2.13 IP/FW software that has a MLPPP bundle with two T1's for Internet Access. Everything looks great, good throughput. As soon as he is using ACL's and CBAC on the Multilink interface, the throughput is very low, maybe 200-300 Kbps. What options do we have?

2 REPLIES
New Member

Re: MLPPP and ACL problem

one posibility is that your access lists could be too restrictive. use the links provided below to verify you configuration and troubleshoot throughput reduction on employment of access control lists.

use the [show ip access-list] command to determine of too much traffic is being denied.

http://www.cisco.com/en/US/customer/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml#trouble

the following link will provide indepth information on how to configure access lists.

http://www.cisco.com/en/US/customer/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml

troubleshooting CBAC:

http://www.cisco.com/en/US/customer/products/sw/secursw/ps1018/products_tech_note09186a0080094112.shtml

New Member

Re: MLPPP and ACL problem

Hi,

Thanks for your message. I am sorry that I did not mention, but the same ACL and CBAC do not have any impact on the performance when only one T1 Internet Access is used (PPP encapsulation). Also, when two T1's are used (MLPPP) the router CPU is low - 7-10%

Gabi

90
Views
0
Helpful
2
Replies