Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

eap
New Member

mls flow full

Hi,

We have a 6509 that I applied the command, set mls flow full, to yesterday as suggested by the TAC article for looking for the Nachi worm. I want to get rid of that command but am not sure how. I like the IOS where to negate a command you simply say no and repeat the command. Not so with CatOS.

Any help would be appreciated,

Paula

3 REPLIES
Cisco Employee

Re: mls flow full

If you do not have access lists on any MLS-RP, the default flow mask is destination flow. You can change it using command

Console (enable) set mls flow ?

destination Set flow type Destination only

destination-source Set flow type Destination and Source

full Set flow type Full

Console (enable) set mls flow destination

Configured IP flowmask is set to destination flow.

eap
New Member

Re: mls flow full

Thanks,

Is that a default setting because that command was not in our previous non-default configuration?

Paula

Cisco Employee

Re: mls flow full

Yes

98
Views
0
Helpful
3
Replies