X ----ethernet 2620 serial.........serial2620ethernet -----Y
The set up is like this. R1 and R2 are 2 2620s connected by serial link. R1 has ethernet falling in network X. R2 has ethernet falling in network Y. R1 is configured as Home agent, R2 as Foreign agent. R2 has IRDP enabled on ethernet interface.
When the laptop is moved from R1s ethernet to R2, I can see a mobile host route (/32) on the R2s routing table ( M). But the registration between the mobile host and the HA is not happening.
Does the laptop require a Mobile IP client, to contact or register with the HA ?
Anybody who have played with Mobile IP , Please advise
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...