Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

modem setup over voip

I have two Philips PBX's connected via Cisco 2651 routers - ISDN PRI on one side and ISDN BRI on the other side. When I make modem calls to the other side, the connected speed trails down to 300 baud. I know I need to set up modem pass-thru, but it seems like it is only supported on the AS5300. Is there a way to get around the problem on a 2600 router?

1 REPLY
Anonymous
N/A

Re: modem setup over voip

you can enable fax-relay with 14.4k

or disable fax-relay and run a high codec g726, g711.

on both ends

136
Views
0
Helpful
1
Replies