I'm guessing it cannot be done, as the all privileges (StrataCom) level doesn't seem to have a command that would allow me to modify the DC Threshold levels from the default levels of 42-54Vdc.
I know you can disable the monitoring of the DC-unit but I'm really keen to keep the MGX monitoring the DC voltages but making the DC lower threshold something more meaningful, as below 47Vdc the MGX will shutdown.
I know when I asked the developers about changing the temp. on the MGX8220 to have a lower measurement, was told it was hard coded in the software and there was no way of changing it. I know its not addressing your question about the DC issue, but I'm thinking its probably in the same coding. Hopefully its not in the same coding.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...