Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Module/OS upgrade in catalyst 5000

Hi,

I am fairly new to CISCO environment. I am trying to upgrade two switch 10 Base-TX(WS-X5012A) modules in a 3 yrs old catalyst 5000(Supervisor engine II) to a 100 Base-TX module (WS-x5224).

I found the CatOS version requirement for the WS-x5224 is a higher version than what i have.So i need to upgrade the CatOS. Can you geeks help me how i can i do this? Where from i can download the latest CatOS? What other prior steps i should pursue?

I am in need of some step-by-step documentation.Can you help me?

thanks

vensub

Below is the version info:(show ver)

----------------

WS-C5000 Software, Version McpSW: 4.3(1a) NmpSW: 4.3(1a)

Copyright (c) 1995-1998 by Cisco Systems

NMP S/W compiled on Nov 23 1998, 15:03:28

MCP S/W compiled on Nov 23 1998, 15:04:57

System Bootstrap Version: 4.2(1)

Hardware Version: 2.7 Model: WS-C5000 Serial #: 013355308

Mod Port Model Serial # Versions

--- ---- ---------- --------- ----------------------------------------

1 2 WS-X5509 013355308 Hw : 2.7

Fw : 4.2(1)

Fw1: 4.3(1)

Sw : 4.3(1a)

2 48 WS-X5012A 012833053 Hw : 1.0

Fw : 4.2(1)

Sw : 4.3(1a)

3 48 WS-X5012A 012833355 Hw : 1.0

Fw : 4.2(1)

Sw : 4.3(1a)

4 48 WS-X5012A 012833376 Hw : 1.0

Fw : 4.2(1)

Sw : 4.3(1a)

5 24 WS-X5224 011682408 Hw : 1.4

Fw : 3.1(1)

Sw : 4.3(1a)

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 16384K 10003K 6381K 8192K 3840K 4352K 256K 110K 146K

Uptime is 21 days, 22 hours, 15 minutes

1 REPLY
New Member

Re: Module/OS upgrade in catalyst 5000

Vensub,

Download and upgrade instructions can be found at:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_3/config/images.htm

Be sure to reference your hw configuration in the documentation as the procedures vary from hw-to-hw.

The supervisor card (once code is upgraded and rebooted) will load the other modules with the new code during the boot cycle.

The software can be downloaded from: (LOGIN REQUIRED)

http://www.cisco.com/kobayashi/sw-center/sw-lan.shtml

Regards,

Paul

99
Views
0
Helpful
1
Replies
CreatePlease to create content