Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Monitor 4 T1s with 1 IMA group

I have 4 T1s and 1 IMA group setup. When I try to setup ip addresses for each ATM interface, I got ip address overlap. Is there a way that I can setup ip address for each of the AMT interface so I can monitor them via Ping/SNMP?

Thank you.

  • Other Network Infrastructure Subjects
1 REPLY
Silver

Re: Monitor 4 T1s with 1 IMA group

I don't think this is possible as all interfaces have to be grouped under one IP address to form the IMA group.

But you can probe the individual interface using the device manager.

82
Views
0
Helpful
1
Replies