Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Monitor execcsive usage on T1 interface

Over the past few days I am seeing a large increase of inbound traffic on a T1 circuit. So much so that the circuit is saturated about 8 or 9 hours a day. Is there a way that I can monitor this to see where this traffic is comming from? I have a 7206 VXR, with the T1 in question, an ATM DS3 circuit for upstream, and a DS3 ATM for DSL customers. The traffic is coming in the T1 and I think out the DSL DS3.

Thanks,

Mitchel

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Monitor execcsive usage on T1 interface

Mitchel,

ip accounting in your T1 interface, or others, can be used to Identify where this traffic is going to and from (assuming it's IP traffic). Here's a link to show you how to enable it and show your stats.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipras_r/1rfip2.htm#1020199

(See Ip accounting if it does not bring you right there)

Hope this helps you,

Don

2 REPLIES
Silver

Re: Monitor execcsive usage on T1 interface

Mitchel,

ip accounting in your T1 interface, or others, can be used to Identify where this traffic is going to and from (assuming it's IP traffic). Here's a link to show you how to enable it and show your stats.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipras_r/1rfip2.htm#1020199

(See Ip accounting if it does not bring you right there)

Hope this helps you,

Don

New Member

Re: Monitor execcsive usage on T1 interface

Thanks Don. Just what I needed.

Mitchel

88
Views
0
Helpful
2
Replies