Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring Cat4006 switch bandwidth

I would like to know if there is any command, technique or recommendations on measuring the bandwidth consumption (in % or bytes/sec) on a Cat 4K switch. Thanks.

3 REPLIES
Silver

Re: Monitoring Cat4006 switch bandwidth

"show system" will show over all backplane utilization and if you want a per port type utilization you could use a tool like MRTG to get this. Here's a link for MRTG if you want to look into this.

http://people.ee.ethz.ch/~oetiker/webtools/mrtg/

Hope this helps you,

Don

New Member

Re: Monitoring Cat4006 switch bandwidth

Thanks Don. Is there any other commands I can use to get more info to substantiate that my switch is not "overloaded"?

Silver

Re: Monitoring Cat4006 switch bandwidth

You and use the "ps" commands to look at your Supervisor CPU as well if this is of interest to you. Other than that good SNMP tools, like MRTG , are the best ways to look at specific port utilization.

Hope this helps you,

Don

97
Views
0
Helpful
3
Replies
CreatePlease login to create content