I have a DS3 connection coming into a 7204 Cisco. We have only provisioned 6MB of that pipe. Is there any way to monitor whether or not the provider is giving us all that we have provisioned? --From the router side? or is this only possible from the telco side?
Basically we want to make sure the provider is giving us what we are paying for. I have started looking at the MIB entries supported by the router, and haven't found anything yet.... (but have just started)...
i realize you can set the bandwitdh params on the ATM interfaces, and monitor this-- but would this do what we're needing? -- if it changed (say the provider dropped our pipe to 3MB) would it show up?
I am not quite sure giving you the right answer to your question, but you might test the MRTG-Tool (it is free) or Cisco QDM. QDM is a little peace of software which you have to load into the flash of your router. The user interface is http-based ...
QDM is used for configuring QoS Policies. Nevertheless, it is offering a monitoring function which provides some interfase statistics (packet rate etc.)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...