Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Monitoring routers

Good morning,

We have a frame relay network with fractional t-1 and 1751 routers. Over many of our links, we seem to be dropping connections or experience slow response times if only for a second or two, which makes all the difference in the world for our WAN application. We've discussed this with our provider, but they say they don't see anything. The trunk goes through a rural location, so we have to deal with a couple of providers, each saying the problem is not theirs...Recently, this seems to be happening quite often with a few of our locations.So I have a couple of questions:

1. How can we troubleshoot this?

2. Is there a way to save to a text file the information I get when typing SH INT?

Thanks,

Chris

3 REPLIES
New Member

Re: Monitoring routers

Check for the various errors you get in the show int command according to the following document and see if they are increasing.

http://cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml

Also you can log the messages in different ways. Some things in the following doc are particular to 2950 switch.

http://cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080150bbf.html#74820

Thanx,

Praful

Anonymous
N/A

Re: Monitoring routers

Thanks for the info, Praful!

New Member

Re: Monitoring routers

Hi Chris,

You can also check if your card is ok by performing a hardware loopback test.

Loopback Tests for T1/56K Lines

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a754b.shtml

Best Regards,

Ansley R. Verzosa

178
Views
0
Helpful
3
Replies
CreatePlease login to create content