monitoring the system messages on a cat .1900 sw

[chhussey]

I am trying to look at bridging traffic on the monitor port of a cat..1900

but the unicast floofing and multicast flooding are disabled by default on the monitoring port. This is preventing the sniffer from capturing these packets. I tried to enadle this feature but was unable to do so.

How do I solution this. code ver...

Version V8.01.05

[r-simpson]

You might be running into some feature conflict issue here.

Check out http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35xu/scg/kiconfig.htm#xtocid5742