05-23-2002 02:48 AM - edited 03-01-2019 09:50 PM
Hello all,
How do I remove the following mac address from the switch without reboot?
cat6509> (enable) sh cam 00-01-64-70-a5-c8
* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
X = Port Security Entry
VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol
Type]
---- ------------------ -----
-------------------------------------------
1 00-01-64-70-a5-c8 R# 16/1
Total Matching CAM Entries Displayed = 1
if you wish to know why -
Had two Supervisor modules in one 6509 switch for redundancy. Removed one of the Supervisor modules and installed it on a second switch so now each switch has a single supervisor card. The supervisor modules have the MSFC card. From the original switch MSFC card I can ping anything on the network. From the new install MSFC card I can't ping anything except its own switch. Correction, I can ping and if I run icmp debugs on a router I can see the ICMP packets but the MSFC does not see any replys. I have found the problem. The original switch still holds the mac address of the MSFC card. I tried to clear the cam table but this does not clear R# mac addresses.
05-23-2002 03:55 AM
is it in your arp table? what's your arp timeout?
05-23-2002 05:16 AM
Yes, it's in the arp table of the original switch.
05-23-2002 04:57 AM
try "clear cam 00-01-64-70-a5-c8"
05-23-2002 05:19 AM
I have tried the above. will not clear R# entries.
05-23-2002 06:55 AM
The entry should have been removed when the MSFC was removed. I would suggest opening a case with TAC and having them due a bug scrub.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide