11-15-2001 01:34 PM - edited 03-01-2019 07:24 PM
My company have a Catalyst 6506 with two supervisor engines (WS-X6K-SUP1A-2GE)and both appear to work fine althougt the system LED is red, both in primary and secondary.
Does anyone have any clue about it?
Thanks
Eduardo Ribeiro
11-15-2001 03:56 PM
Do a show mod, you may see both of them faculty as the status.
a) Do a "show system" and you would probably see something is faulty.
You need two power supply for the system to come out faulty status.
b) you can also do a show test 1 and show test 2.
to see anything if faculty
Please use the following doc
11-16-2001 07:47 AM
Make sure that both power supplies are on. If one of them is off, system LED on both supervisory modules lits to indicate this.
11-19-2001 03:40 AM
Thanks,
But using the show test 2, i discovered that the EOBC is faulty. How can i solve this problem?
11-19-2001 06:37 AM
Most likely a hardware failure. But you can try reseating the module to see if that helps.
11-20-2001 08:19 AM
But what is this Ethernet Out-of-Band Channel? What it does?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: