Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

MSFC redundancy

Does somebody tell me if there some example about Catalyst 6500 with two Supervisor and two MSFC to have redundancy for 2 and 3 level ?

2 REPLIES
DWA
Community Member

Re: MSFC redundancy

Hello

look here

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm

We have passed on level two catos command :

"set system highavailability enable"

and on lvel three :

"redundancy

high-availability

single-router-mode"

Cisco Employee

Re: MSFC redundancy

You can use High-avaiilibility on layer 2 side. For MSFCs, you have few options such as HSRP, HSRP with config-sync and SRM. The following page should help

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm

Also take a look at the following thread

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26mode%3Dnew%26location%3D.ee8b5d9/1

104
Views
0
Helpful
2
Replies
CreatePlease to create content