We have a Cat 6509 with two Sup2 modules plus MSFC2's. We upgraded the Native Switch software and MSFC software on both modules. Before upgrade, we could reach both MSFCs. After system reset, Module 15 was shown as not installed. Active supervisor was in slot 1, and we used the 'switch console' command to reach module 15 to see if it was in rommon mode. But only 'type ^C^C^C to switch back' message was displayed and we did not get any cli prompt from module 15. When we 'switch supervisor' to slot 2, 'switch console' command works fine to reach module 16. Does anyone have a solution for this problem?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...