Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MSFC2 Redundancy and Synchronization

We have the following commands in our designated MSFC2 in Slot 15 of Cat 6506 in startup and running configs.

redundancy

high-availability

config-sync

Yet, when we session 16 we notice that the MSFC2 in slot 16 has no config at all. Comes up with Router> prompt.

Then we went to enable mode and did Config terminal and entered the config from designated MSFC2. Our understanding is that you don't need to do this if config-syn is enabled on designated (slot 15).

IOS version is 12.1(11b)E4

Please explain

Alphonse

alphonse.stanislaus@hp.com

1 REPLY
Cisco Employee

Re: MSFC2 Redundancy and Synchronization

Force syncronization by doing a "wr mem" and see if it helps. Also the following page should help

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm#xtocid1228926

82
Views
0
Helpful
1
Replies