Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

MSFC2 Upgrade using the new code - boot mode

When i tried to upgrade the existing code to c6msfc2-jsv-mz.122-14.ZA2.bin it went to boot mode. I had to backout to the old one again since it dint do any routing funcitons. Is there any bug in the code or is not compatible with Catalyst 6509 running 7.1(2).

2 REPLIES
Bronze

Re: MSFC2 Upgrade using the new code - boot mode

Check out the release notes section for this release and see if you need to take care of something

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_3827.htm

Community Member

Re: MSFC2 Upgrade using the new code - boot mode

Have you checked that c6msfc20jsv-mz.x.y.z is the only bootable image in the bootflash? Is your BOOT variable set correctly? (sh bootvar)

90
Views
0
Helpful
2
Replies
CreatePlease to create content