Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MTU Problem

Hi team.

I´m having some problems in a Bridging network. I have a Cisco 7513 then ATM cloud and then a Catalyst 2924 whit a STM-1 ATM, doing binding between PVC and VLAN.

The problem is i can´t do ping greater than 1484 b.

In the 7513 i have already configured RBE, whit the ip in the Loopback interface ( IP unnumbered ). And the MTU is configured in 1500 in the subint ATM

I did some test´s and the router is doing something very strange.

I had configured a PVC whit RBE and it didn´t work, but if i create a new interface and paste the pvc in this inteface works fine. If i delete the PVC and create again it didn´t work. And the again the same create a new interface and works again etc...

I think is a Bug but.........

I hear any comments.

Thks all.

Pablo.

2 REPLIES
New Member

Re: MTU Problem

Certainly appears to be bug related.

http://www.cisco.com/cgi-bin/Support/Bugtool/launch_bugtool.pl

Insert your software version into this tool and check your results. If you are unsuccessful contact the Technical Assistance Center; though expect a request for code upgrade early in the process.

New Member

Re: MTU Problem

Remove "mtu 1500" from the ATM interface and try adding " ip mtu 1500 " and see whether it works.

86
Views
0
Helpful
2
Replies
CreatePlease to create content