Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Multi-DC Auto-RP with MSDP Design Question

Most of Cisco design seem to recommend Anycast....then the latest DCAP came out which apppears to combine anycast, auto-rp and msdp but there isn't much sample configs:

I want to setup the multicast base on page 2-46.

http://www.cisco.com/en/US/solutions/ns340/ns414/ns742/ns743/ns758/networking_solutions_products_genericcontent0900aecd806c3a8c.pdf

I have 3 DC link by a MPLS WAN. On each DC redundant cores, I assume I setup Anycast with MSDP and do Auto-RP on the Anycast RP address.

Assuming Layer 3, on the downstream Distribution and Access, I believe I should setup a static RP pointing to the local DC Cores (ie ip pim rp-address 10.100.106.1 or should I just setup autorp like Edge on next sentence)

On the Edge WAN routers, I will setup "Ip pim autorp listener"

So is the above correct?

I have another question on the "override" option below

*******DC redundant Cores*****

interface Loopback105

description ****MSDP LOCAL PEER ADDRESS****

ip address 10.100.105.1 255.255.255.255

!

interface Loopback106

description ****ANYCAST RP ADDRESS****

ip address 10.100.106.1 255.255.255.255

ip pim sparse-mode

ip msdp peer 10.100.105.2 connect-source Loopback105

ip msdp cache-sa-state

ip msdp originator-id Loopback105

ip access-list standard AUTO-RP-CONTROL-GROUP

permit   224.0.1.39

permit  224.0.1.40

ip pim rp-address 10.100.106.1 AUTO-RP-CONTROL-GROUP (do I need the “override” option?)

ip pim send-rp-announce 10.100.106.1 scope 16 group-list AUTO-RP-CONTROL-GROUP

ip pim send-rp-discovery scope 16

405
Views
0
Helpful
0
Replies
CreatePlease login to create content