We added a 2nd point-to-point T1 connection to our 2650XM router that goes to a Nortel BLN (Backbone Link Node) Router. The problem we have is that once we add the second T1 to the multi-link PPP group, all traffic stops routing.
Has anyone seen anything like this before? What about some good debugs to troubleshoot this? I'm thinking multi-link ppp incompatibilities/configuration options between the Cisco and the Nortel MLPPP implementation, but need some ideas on how I can prove it is one side or the other.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...