Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Multi-Link PPP with two T-1's

When a T-1 in a Multi-link bundle goes down, then comes back up, the T-1

fails to become active in the bundle (stays inactive_ unless I remove the

PPP multi-link statements on the T-1 at both end and then re-apply them. All

routers are running IOS 12.2(7) accross multiple pathform, Cisco 7206VXR,

Cisco 2621, and Cisco 3660.

1 REPLY
Cisco Employee

Re: Multi-Link PPP with two T-1's

That looks like a ios defact t me..Need to know any error message that you may have seen while T1 trying to bundle it with multilink again..Pl. enable following debug while T1 is coming up again.

debug ppp nego

debug ppp multilink

Pl. post it here if possible.

247
Views
0
Helpful
1
Replies
CreatePlease to create content