I have a couple of questions about the operation of SVI VLAN routing on the 3560 switch.
First, I have one 3560 switch that has SVI VLAN interfaces built for several VLANs. Is there anything I should know about applying ACL's to restrict traffic between these interfaces? For instance, let's say 10.10.1.10 is in VLAN 1 and 10.10.3.10 is in VLAN 3. I have SVI interfaces built for both of these interfaces. Now I want to restrict 10.10.1.10 from reaching 10.10.3.10, or vice versa, or some combination of some networks to a certain host on a certain VLAN. I have tried applying something like:
access-list 101 deny ip host 10.10.3.10 10.10.1.0 0.0.0.255
permit ip any any
and this doesn't seem to deny the desired traffic to the 10.10.1.0. How exactly does this SVI routing work?
Secondly, I've heard that I shouldn't have more than a certain number of SVI interfaces in a box. What is the rule of thumb for the most that should be setup on 3560?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.