Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Multicast distributed switching

I got follow message on C7206VXR with NPE-G1 processing egine.

"Multicast distributed switching is not allowed on tunnel interfaces"

I can find this message when I show running-config, or write memory.

How can I remove this message, and Why I got this message?

there are no mroute-cache or ip multicast command

and 'cause this is C7206, No distributed option on mroute-cache.

what's the problem?

  • Other Network Infrastructure Subjects
3 REPLIES

Re: Multicast distributed switching

May be if you can provide a snapshot of your config, with passwords and ip addresses masked, for further troubleshooting...

New Member

Re: Multicast distributed switching

I Got this message on Default configuration.

Means When I first boot up this device, I got this message.

Diags are following

- 7206VXR/NPE-G1 7206VXR with NPE-G1 processing engine

- MEM-NPE-G1-512MB Two 256MB mem modules (512MB total) for NPE-G1 in 7200

- MEM-NPE-G1-FLD128 Cisco 7200 Compact Flash Disk for NPE-G1, 128 MB Option

- C7200-I/O Cisco 7200 Input/Output Controller

- MEM-I/O-FLD128M Cisco 7200 I/O PCMCIA Flash Disk, 128 MB Option

- PA-2T3+ 2 Port T3 Serial Port Adapter Enhanced

- PA-8T-V35 8-Port Serial, V.35 Port Adapter

- PWR-7200-ACE= Cisco 7200 AC Power Supply With European Cord

- MAS-7200-CBLMGMT Cisco NPE-G1 Cable Management Bracket

no further configuration on it.

New Member

Re: Multicast distributed switching

It was a BUG.

ID is CSCdz25306.

Thanks

156
Views
0
Helpful
3
Replies