Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Multicast Output explanation

Hello

Im not convinced with the following 'sh ip mroute ' output. The Flags CJT are missing eventhough there are directly connected members s . But evrythng seems to be working fine. Also what is 6d14h/stopped,

Thanks

ldn-lw4-r106# sh ip mroute

IP Multicast Routing Table

Flags: D - Dense, S - Sparse, s - SSM Group, C - Connected, L - Local,

P - Pruned, R - RP-bit set, F - Register flag, T - SPT-bit set,

J - Join SPT, M - MSDP created entry, X - Proxy Join Timer Running

A - Advertised via MSDP, U - URD, I - Received Source Specific Host

Report

Outgoing interface flags: H - Hardware switched

Timers: Uptime/Expires

Interface state: Interface, Next-Hop or VCD, State/Mode

(*, 239.255.9.1), RP 169.123.90.102, flags: SJPC

Incoming interface: Tunnel0, RPF nbr 169.128.38.2, Partial-SC

Outgoing interface list: Null

(165.21.4.50, 239.255.9.1), 2d06h/00:03:19, flags: T

Incoming interface: GigabitEthernet1/2, RPF nbr 165.25.4.2, Partial-SC

Outgoing interface list:

Tunnel0, Forward/Sparse-Dense, 2d06h/00:03:03

(165.21.4.52, 239.255.9.1), 2d06h/00:03:29, flags: T

Incoming interface: GigabitEthernet1/2, RPF nbr 165.25.4.2, Partial-SC

Outgoing interface list:

Tunnel0, Forward/Sparse-Dense, 2d06h/00:03:03

(165.21.4.53, 239.255.9.1), 2d06h/00:02:58, flags: T

Incoming interface: GigabitEthernet1/2, RPF nbr 165.25.4.2, Partial-SC

Outgoing interface list:

Tunnel0, Forward/Sparse-Dense, 2d06h/00:03:02

(165.21.4.54, 239.255.9.1), 6d14h/00:03:28, flags: T

Incoming interface: GigabitEthernet1/2, RPF nbr 165.25.4.2, Partial-SC

Outgoing interface list:

Tunnel0, Forward/Sparse-Dense, 6d13h/00:03:02

(165.21.4.55, 239.255.9.1), 2d06h/00:03:18, flags: T

Incoming interface: GigabitEthernet1/2, RPF nbr 165.25.4.2, Partial-SC

Outgoing interface list:

Tunnel0, Forward/Sparse-Dense, 2d06h/00:03:02

1 REPLY
Bronze

Re: Multicast Output explanation

6d14h/ means 6 days, 14 hours and "stopped" means that timing out of this entry is not determined by this expire timer.

429
Views
0
Helpful
1
Replies
CreatePlease to create content