Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Multicasting on Cat4507 - wrong feature set ???

Hello gurus,

I've been trying to enable inter-vlan multicast on Cat 4507 switch. Now I've read, that all you need is

"ip multicast-routing" and "ip pim parse-mode" for interfaces on switch. First command works fine, the second - doesn't : here is a reply from switch

switch(config)#int Gi1/1

switch(config-if)#ip pim ?

% Unrecognized command

switch(config-if)#ip ?

Interface IP configuration subcommands:

access-group Specify access control for packets

arp Configure ARP features

dhcp DHCP

igmp IGMP interface commands

verify verify

Is it just a problem with feature set or am I missing something ?

Thanks,

Alex

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: Multicasting on Cat4507 - wrong feature set ???

Hello Alex,

you need a layer 3 to configure multicast on, e.g. a VLAN interface:

interface Vlan2

ip pim sparse-dense-mode

HTH,

GP

1 REPLY
VIP Purple

Re: Multicasting on Cat4507 - wrong feature set ???

Hello Alex,

you need a layer 3 to configure multicast on, e.g. a VLAN interface:

interface Vlan2

ip pim sparse-dense-mode

HTH,

GP

113
Views
0
Helpful
1
Replies
CreatePlease to create content